How-To How to rig the Inu Posted on July 4, 2022 1. Bend your soft plastic of choice and measure where the plastic tube should enter each section. 2. Insert the tube at a 30-degree angle near the nose of the bait. 3. Push the tube through the center of the bait, where you marked it earlier. 4. Next, push the tube through the tail section. Ideally, the bends in the bait will be equally spaced. 5. Snip the tube sections close to the bait. To better secure the tubes, add a dab of super glue. 6. Before going any further, thread a hook on your line, point facing away from the tag end. 7. Thread your line through each section of the inserted tubes, ending at the tail of the bait. 8. Tie a split ring to your line. This is your only connection, so make it good. 9. Insert the hook into the bait, making certain the eye perfectly aligns with the tube.